3 EASY STEPS TO MAINTAIN YOUR HOME’S WATER HEATER

0
198

Water heaters are the most dependable appliance which is used by every house now and then and has got popular since a decade. They are really reliable and work smoothly without any hindrance. Not only houses, people find water heaters convenient even at work places and schools as well. It is mainly used for heating up water for domestic purposes either by gas or electric systems. The appliance undeniably looks complex but you can keep them working for days, months and years without any repair by following few easy steps just sitting at home. From now onwards you do not have to call the mechanic several times and spend money on them if you follow these easy and inexpensive procedure mentioned below.

Usually, people prefer the tank water heaters at home since they work quietly and works for years without any doubt. Few things that you need to keep in mind, regulating the temperature and insulation has to be adjusted once and other than this, rinse the tank and check the anode rod that has to be done after every six months so that it is free from any foreign particles or clogging. Water heaters are much uncomplicated to work upon but if you find it baffling, then always call an expert. Before starting the maintenance, do not forget to wear safety gloves, safe clothes in case you are working on electric water heaters and glasses. You may also need a pressure washer to clean your water heater. Let’s break down the whole process into three steps:

STEP 1 – Check the temperature of the water heater

There is a temperature setting panel in the water heater where you can easily adjust the temperature to save some energy. The manufacturer sets the ideal temperature to 140 degrees which are unnecessary for any household purposes. Reduce the degree to 120 or 115 and you will save 5 percent of the energy. It can be a knob like in the tanks or a thermostat in the electric water heaters. Thus by lowering the temperature, you save energy, prevent the water from overheating, corrosion of the rods, setting of mineral elements, and also increases the safety. You can easily go through the instruction book that comes along with the product and follow the easy steps to set the thermostat. Do remember to turn off the power supply before unlocking each and every part of the tankless water heater. Check Some good tankless water heater reviews.

STEP 2 – Evaluate the temperature and pressure valves

Here comes, the examination of the most important part of a water heater. Check the pressure relief valve and temperature valve often to reduce the chances of explosion and corrosion of the rods. The TRP valve unveils itself when the temperature increases and to release the pressure from the water heater. It can terminate to function if the TRP valve gets in contact with a tough layer of mineral and corrosion. To investigate whether it’s working properly or not, raise the lever up and down, few times and then flush out the hot water. If the hot water comes out in a gush from the draining pipe that means the valve is working absolutely fine.

STEP 3- flush after checking the water heater

With the due course of time, minerals and sediments tend to settle down at the bottom of the water heaters. It is important to eliminate and clear the substances from the heater to reduce the further chances of corrosion and rusting of rods and increases the productivity of the water heaters. Place a container or a bucket to drain out all the water from the heater. Turn the valve piece clockwise or lift up the handle, then, clean and wash the bottom to make sure no sediment is left. The draining of water can take some time around 30 minutes depending upon the clarity of the water. Drain and repeat few times until the water runs clear and clean. Then put back the draining pipes, fill the heater again with water and turn on the power supply.

People often ask how many times the water heaters must be cleaned and checked. The answers vary and the professionals always mention that it depends completely on the hardness of the water you receive and how often the debris settles in the heater. The debris can enhance the malfunction of the parts and can reduce the temperature or sometimes increase to an uncontrollable condition thus by exploding. To completely avoid those extreme conditions, experts recommend that water heaters require maintenance after every 6 months. After all, precaution is better than cure.